<< Chapter < Page Chapter >> Page >
ε l = vB . size 12{ { {ε} over {l} } = ital "vB" "." } {}

Solving this for the Hall emf yields

ε = Blv ( B , v , and l , mutually perpendicular ) , size 12{ε= ital "Blv"``` \( B,`v,`"and"`l,`"mutually perpendicular" \) ,} {}

where ε size 12{ε} {} is the Hall effect voltage across a conductor of width l size 12{l} {} through which charges move at a speed v size 12{v} {} .

Diagram showing an electron moving to the left in a three-dimensional rectangular space with velocity v. The magnetic field is oriented out of the page. The electric field is down. The electric force on the charge is up while the magnetic force on the charge is down. An illustration of the right hand rule shows the thumb pointing to the left with v, the fingers out of the page with B, and the force on a positive charge up and away from the palm.
The Hall emf ε size 12{ε} {} produces an electric force that balances the magnetic force on the moving charges. The magnetic force produces charge separation, which builds up until it is balanced by the electric force, an equilibrium that is quickly reached.

One of the most common uses of the Hall effect is in the measurement of magnetic field strength B size 12{B} {} . Such devices, called Hall probes , can be made very small, allowing fine position mapping. Hall probes can also be made very accurate, usually accomplished by careful calibration. Another application of the Hall effect is to measure fluid flow in any fluid that has free charges (most do). (See [link] .) A magnetic field applied perpendicular to the flow direction produces a Hall emf ε size 12{ε} {} as shown. Note that the sign of ε size 12{ε} {} depends not on the sign of the charges, but only on the directions of B size 12{B} {} and v size 12{v} {} . The magnitude of the Hall emf is ε = Blv size 12{ε= ital "Blv"} {} , where l size 12{l} {} is the pipe diameter, so that the average velocity v size 12{v} {} can be determined from ε size 12{ε} {} providing the other factors are known.

Diagram showing a tube with diameter l with one end between the north and south poles of a magnet. The charges are moving with velocity v within the tube and out of the page. The magnetic field B is oriented across the tube, from the north to the south pole of the magnet. The force on the charges is up for positive charges and down for negative charges. e m f = B l v.
The Hall effect can be used to measure fluid flow in any fluid having free charges, such as blood. The Hall emf ε size 12{ε} {} is measured across the tube perpendicular to the applied magnetic field and is proportional to the average velocity v size 12{v} {} .

Calculating the hall emf: hall effect for blood flow

A Hall effect flow probe is placed on an artery, applying a 0.100-T magnetic field across it, in a setup similar to that in [link] . What is the Hall emf, given the vessel’s inside diameter is 4.00 mm and the average blood velocity is 20.0 cm/s?

Strategy

Because B size 12{B} {} , v size 12{v} {} , and l size 12{l} {} are mutually perpendicular, the equation ε = Blv size 12{ε= ital "Blv"} {} can be used to find ε size 12{ε} {} .

Solution

Entering the given values for B size 12{B} {} , v size 12{v} {} , and l size 12{l} {} gives

ε = Blv = 0.100 T 4 . 00 × 10 3 m 0 .200 m/s = 80.0 μV alignl { stack { size 12{ε= ital "Blv"= left (0 "." "100"`T right ) left (4 "." "00" times "10" rSup { size 8{ - 3} } `m right ) left (0 "." "200"`"m/s" right )} {} # ="80" "." 0`"μV" {}} } {}

Discussion

This is the average voltage output. Instantaneous voltage varies with pulsating blood flow. The voltage is small in this type of measurement. ε size 12{ε} {} is particularly difficult to measure, because there are voltages associated with heart action (ECG voltages) that are on the order of millivolts. In practice, this difficulty is overcome by applying an AC magnetic field, so that the Hall emf is AC with the same frequency. An amplifier can be very selective in picking out only the appropriate frequency, eliminating signals and noise at other frequencies.

Got questions? Get instant answers now!

Section summary

  • The Hall effect is the creation of voltage ε size 12{ε} {} , known as the Hall emf, across a current-carrying conductor by a magnetic field.
  • The Hall emf is given by
    ε = Blv ( B , v , and l , mutually perpendicular ) size 12{ε= ital "Blv"``` \( B,`v,`"and"`l,`"mutually perpendicular" \) } {}
    for a conductor of width l size 12{l} {} through which charges move at a speed v size 12{v} {} .

Conceptual questions

Discuss how the Hall effect could be used to obtain information on free charge density in a conductor. (Hint: Consider how drift velocity and current are related.)

Got questions? Get instant answers now!

Problems&Exercises

A large water main is 2.50 m in diameter and the average water velocity is 6.00 m/s. Find the Hall voltage produced if the pipe runs perpendicular to the Earth’s 5 . 00 × 10 5 -T size 12{5 "." "00" times "10" rSup { size 8{ - 5} } "-T"} {} field.

7 . 50 × 10 4 V

Got questions? Get instant answers now!

What Hall voltage is produced by a 0.200-T field applied across a 2.60-cm-diameter aorta when blood velocity is 60.0 cm/s?

Got questions? Get instant answers now!

(a) What is the speed of a supersonic aircraft with a 17.0-m wingspan, if it experiences a 1.60-V Hall voltage between its wing tips when in level flight over the north magnetic pole, where the Earth’s field strength is 8 . 00 × 10 5 T? size 12{8 "." "00" times "10" rSup { size 8{ - 5} } `"T?"} {} (b) Explain why very little current flows as a result of this Hall voltage.

(a) 1.18 × 10 3 m/s

(b) Once established, the Hall emf pushes charges one direction and the magnetic force acts in the opposite direction resulting in no net force on the charges. Therefore, no current flows in the direction of the Hall emf. This is the same as in a current-carrying conductor—current does not flow in the direction of the Hall emf.

Got questions? Get instant answers now!

A nonmechanical water meter could utilize the Hall effect by applying a magnetic field across a metal pipe and measuring the Hall voltage produced. What is the average fluid velocity in a 3.00-cm-diameter pipe, if a 0.500-T field across it creates a 60.0-mV Hall voltage?

Got questions? Get instant answers now!

Calculate the Hall voltage induced on a patient’s heart while being scanned by an MRI unit. Approximate the conducting path on the heart wall by a wire 7.50 cm long that moves at 10.0 cm/s perpendicular to a 1.50-T magnetic field.

11.3 mV

Got questions? Get instant answers now!

A Hall probe calibrated to read 1 . 00 μV size 12{1 "." "00"`"μV"} {} when placed in a 2.00-T field is placed in a 0.150-T field. What is its output voltage?

Got questions? Get instant answers now!

Using information in [link] , what would the Hall voltage be if a 2.00-T field is applied across a 10-gauge copper wire (2.588 mm in diameter) carrying a 20.0-A current?

1. 16 μV size 12{1 "." "47"`"μV"} {}

Got questions? Get instant answers now!

Show that the Hall voltage across wires made of the same material, carrying identical currents, and subjected to the same magnetic field is inversely proportional to their diameters. (Hint: Consider how drift velocity depends on wire diameter.)

Got questions? Get instant answers now!

A patient with a pacemaker is mistakenly being scanned for an MRI image. A 10.0-cm-long section of pacemaker wire moves at a speed of 10.0 cm/s perpendicular to the MRI unit’s magnetic field and a 20.0-mV Hall voltage is induced. What is the magnetic field strength?

2.00 T

Got questions? Get instant answers now!

Questions & Answers

A golfer on a fairway is 70 m away from the green, which sits below the level of the fairway by 20 m. If the golfer hits the ball at an angle of 40° with an initial speed of 20 m/s, how close to the green does she come?
Aislinn Reply
cm
tijani
what is titration
John Reply
what is physics
Siyaka Reply
A mouse of mass 200 g falls 100 m down a vertical mine shaft and lands at the bottom with a speed of 8.0 m/s. During its fall, how much work is done on the mouse by air resistance
Jude Reply
Can you compute that for me. Ty
Jude
what is the dimension formula of energy?
David Reply
what is viscosity?
David
what is inorganic
emma Reply
what is chemistry
Youesf Reply
what is inorganic
emma
Chemistry is a branch of science that deals with the study of matter,it composition,it structure and the changes it undergoes
Adjei
please, I'm a physics student and I need help in physics
Adjanou
chemistry could also be understood like the sexual attraction/repulsion of the male and female elements. the reaction varies depending on the energy differences of each given gender. + masculine -female.
Pedro
A ball is thrown straight up.it passes a 2.0m high window 7.50 m off the ground on it path up and takes 1.30 s to go past the window.what was the ball initial velocity
Krampah Reply
2. A sled plus passenger with total mass 50 kg is pulled 20 m across the snow (0.20) at constant velocity by a force directed 25° above the horizontal. Calculate (a) the work of the applied force, (b) the work of friction, and (c) the total work.
Sahid Reply
you have been hired as an espert witness in a court case involving an automobile accident. the accident involved car A of mass 1500kg which crashed into stationary car B of mass 1100kg. the driver of car A applied his brakes 15 m before he skidded and crashed into car B. after the collision, car A s
Samuel Reply
can someone explain to me, an ignorant high school student, why the trend of the graph doesn't follow the fact that the higher frequency a sound wave is, the more power it is, hence, making me think the phons output would follow this general trend?
Joseph Reply
Nevermind i just realied that the graph is the phons output for a person with normal hearing and not just the phons output of the sound waves power, I should read the entire thing next time
Joseph
Follow up question, does anyone know where I can find a graph that accuretly depicts the actual relative "power" output of sound over its frequency instead of just humans hearing
Joseph
"Generation of electrical energy from sound energy | IEEE Conference Publication | IEEE Xplore" ***ieeexplore.ieee.org/document/7150687?reload=true
Ryan
what's motion
Maurice Reply
what are the types of wave
Maurice
answer
Magreth
progressive wave
Magreth
hello friend how are you
Muhammad Reply
fine, how about you?
Mohammed
hi
Mujahid
A string is 3.00 m long with a mass of 5.00 g. The string is held taut with a tension of 500.00 N applied to the string. A pulse is sent down the string. How long does it take the pulse to travel the 3.00 m of the string?
yasuo Reply
Who can show me the full solution in this problem?
Reofrir Reply
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 2

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, College physics. OpenStax CNX. Jul 27, 2015 Download for free at http://legacy.cnx.org/content/col11406/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'College physics' conversation and receive update notifications?

Ask