<< Chapter < Page Chapter >> Page >
A hopping kangaroo is shown landing on the ground in one photograph and in the air just after taking another jump in the second photograph.
The work done by the ground upon the kangaroo reduces its kinetic energy to zero as it lands. However, by applying the force of the ground on the hind legs over a longer distance, the impact on the bones is reduced. (credit: Chris Samuel, Flickr)

Finding the speed of a roller coaster from its height

(a) What is the final speed of the roller coaster shown in [link] if it starts from rest at the top of the 20.0 m hill and work done by frictional forces is negligible? (b) What is its final speed (again assuming negligible friction) if its initial speed is 5.00 m/s?

A roller coaster track is shown with a car about to go downhill. The initial height of the roller coaster car on the track is twenty-five meters from the lowest part of the track and its speed v sub zero is equal to zero. The roller coaster’s height from the level part of the track is twenty meters. The finish point of the car is on the level part of the track and the speed at that point is unknown.
The speed of a roller coaster increases as gravity pulls it downhill and is greatest at its lowest point. Viewed in terms of energy, the roller-coaster-Earth system’s gravitational potential energy is converted to kinetic energy. If work done by friction is negligible, all Δ PE g size 12{Δ"PE" rSub { size 8{g} } } {} is converted to KE size 12{"KE"} {} .

Strategy

The roller coaster loses potential energy as it goes downhill. We neglect friction, so that the remaining force exerted by the track is the normal force, which is perpendicular to the direction of motion and does no work. The net work on the roller coaster is then done by gravity alone. The loss of gravitational potential energy from moving downward through a distance h size 12{h} {} equals the gain in kinetic energy. This can be written in equation form as Δ PE g = Δ KE size 12{ - Δ"PE" rSub { size 8{g} } =Δ"KE"} {} . Using the equations for PE g size 12{"PE" rSub { size 8{g} } } {} and KE size 12{"KE"} {} , we can solve for the final speed v size 12{v} {} , which is the desired quantity.

Solution for (a)

Here the initial kinetic energy is zero, so that ΔKE = 1 2 mv 2 . The equation for change in potential energy states that ΔPE g = mgh . Since h is negative in this case, we will rewrite this as ΔPE g = mg h to show the minus sign clearly. Thus,

Δ PE g = Δ KE size 12{ - Δ"PE" rSub { size 8{g} } =Δ"KE"} {}

becomes

mg h = 1 2 mv 2 . size 12{ ital "mg" lline h rline = { {1} over {2} } ital "mv" rSup { size 8{2} } "." } {}

Solving for v size 12{v} {} , we find that mass cancels and that

v = 2 g h . size 12{v= sqrt {2g lline h rline } } {}

Substituting known values,

v = 2 9 . 80 m /s 2 20.0 m = 19 .8 m/s. alignl { stack { size 12{v= sqrt {2 left (9 "." "80"" m/s" rSup { size 8{2} } right ) left ("20" "." 0" m" right )} } {} # " "=" 19" "." "8 m/s" "." {}} } {}

Solution for (b)

Again ΔPE g = ΔKE size 12{ - Δ"PE" rSub { size 8{g} } =Δ"KE"} {} . In this case there is initial kinetic energy, so ΔKE = 1 2 m v 2 1 2 m v 0 2 size 12{Δ"KE"= { {1} over {2} } ital "mv" rSup { size 8{2} } - { {1} over {2} } ital "mv" rSub { size 8{0} rSup { size 8{2} } } } {} . Thus,

mg h = 1 2 mv 2 1 2 m v 0 2 . size 12{ ital "mg" lline h rline = { {1} over {2} } ital "mv" rSup { size 8{2} } - { {1} over {2} } ital "mv" rSub { size 8{0} rSup { size 8{2} } } "." } {}

Rearranging gives

1 2 mv 2 = mg h + 1 2 m v 0 2 . size 12{ { {1} over {2} } ital "mv" rSup { size 8{2} } = ital "mg" lline h rline + { {1} over {2} } ital "mv" rSub { size 8{0} rSup { size 8{2} } } "." } {}

This means that the final kinetic energy is the sum of the initial kinetic energy and the gravitational potential energy. Mass again cancels, and

v = 2 g h + v 0 2 . size 12{v= sqrt {2g lline h rline +v rSub { size 8{0} rSup { size 8{2} } } } } {}

This equation is very similar to the kinematics equation v = v 0 2 + 2 ad size 12{v= sqrt {v rSub { size 8{0} } rSup { size 8{2} } +2 ital "ad"} } {} , but it is more general—the kinematics equation is valid only for constant acceleration, whereas our equation above is valid for any path regardless of whether the object moves with a constant acceleration. Now, substituting known values gives

v = 2 ( 9 . 80 m/s 2 ) ( 20 .0 m ) + ( 5 .00 m/s ) 2 = 20.4 m/s. alignl { stack { size 12{v= sqrt {2 \( 9 "." "80"" m/s" rSup { size 8{2} } \) \( "20" "." 0" m" \) + \( 5 "." "00"" m/s" \) rSup { size 8{2} } } } {} #" "=" 20" "." "4 m/s" "." {} } } {}

Discussion and Implications

First, note that mass cancels. This is quite consistent with observations made in Falling Objects that all objects fall at the same rate if friction is negligible. Second, only the speed of the roller coaster is considered; there is no information about its direction at any point. This reveals another general truth. When friction is negligible, the speed of a falling body depends only on its initial speed and height, and not on its mass or the path taken. For example, the roller coaster will have the same final speed whether it falls 20.0 m straight down or takes a more complicated path like the one in the figure. Third, and perhaps unexpectedly, the final speed in part (b) is greater than in part (a), but by far less than 5.00 m/s. Finally, note that speed can be found at any height along the way by simply using the appropriate value of h size 12{h} {} at the point of interest.

Questions & Answers

if three forces F1.f2 .f3 act at a point on a Cartesian plane in the daigram .....so if the question says write down the x and y components ..... I really don't understand
Syamthanda Reply
hey , can you please explain oxidation reaction & redox ?
Boitumelo Reply
hey , can you please explain oxidation reaction and redox ?
Boitumelo
for grade 12 or grade 11?
Sibulele
the value of V1 and V2
Tumelo Reply
advantages of electrons in a circuit
Rethabile Reply
we're do you find electromagnetism past papers
Ntombifuthi
what a normal force
Tholulwazi Reply
it is the force or component of the force that the surface exert on an object incontact with it and which acts perpendicular to the surface
Sihle
what is physics?
Petrus Reply
what is the half reaction of Potassium and chlorine
Anna Reply
how to calculate coefficient of static friction
Lisa Reply
how to calculate static friction
Lisa
How to calculate a current
Tumelo
how to calculate the magnitude of horizontal component of the applied force
Mogano
How to calculate force
Monambi
a structure of a thermocouple used to measure inner temperature
Anna Reply
a fixed gas of a mass is held at standard pressure temperature of 15 degrees Celsius .Calculate the temperature of the gas in Celsius if the pressure is changed to 2×10 to the power 4
Amahle Reply
How is energy being used in bonding?
Raymond Reply
what is acceleration
Syamthanda Reply
a rate of change in velocity of an object whith respect to time
Khuthadzo
how can we find the moment of torque of a circular object
Kidist
Acceleration is a rate of change in velocity.
Justice
t =r×f
Khuthadzo
how to calculate tension by substitution
Precious Reply
hi
Shongi
hi
Leago
use fnet method. how many obects are being calculated ?
Khuthadzo
khuthadzo hii
Hulisani
how to calculate acceleration and tension force
Lungile Reply
you use Fnet equals ma , newtoms second law formula
Masego
please help me with vectors in two dimensions
Mulaudzi Reply
how to calculate normal force
Mulaudzi
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 1

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, College physics. OpenStax CNX. Jul 27, 2015 Download for free at http://legacy.cnx.org/content/col11406/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'College physics' conversation and receive update notifications?

Ask