<< Chapter < Page Chapter >> Page >

How does sap get to the tops of tall trees? (Recall that a column of water can only rise to a height of 10 m when there is a vacuum at the top—see [link] .) The question has not been completely resolved, but it appears that it is pulled up like a chain held together by cohesive forces. As each molecule of sap enters a leaf and evaporates (a process called transpiration), the entire chain is pulled up a notch. So a negative pressure created by water evaporation must be present to pull the sap up through the xylem vessels. In most situations, fluids can push but can exert only negligible pull , because the cohesive forces seem to be too small to hold the molecules tightly together. But in this case, the cohesive force of water molecules provides a very strong pull. [link] shows one device for studying negative pressure. Some experiments have demonstrated that negative pressures sufficient to pull sap to the tops of the tallest trees can be achieved.

When the piston is raised the liquid stretches somewhat, which results in negative pressure.
(a) When the piston is raised, it stretches the liquid slightly, putting it under tension and creating a negative absolute pressure P = F / A size 12{P= - F/A} {} . (b) The liquid eventually separates, giving an experimental limit to negative pressure in this liquid.

Section summary

  • Attractive forces between molecules of the same type are called cohesive forces.
  • Attractive forces between molecules of different types are called adhesive forces.
  • Cohesive forces between molecules cause the surface of a liquid to contract to the smallest possible surface area. This general effect is called surface tension.
  • Capillary action is the tendency of a fluid to be raised or suppressed in a narrow tube, or capillary tube which is due to the relative strength of cohesive and adhesive forces.

Conceptual questions

The density of oil is less than that of water, yet a loaded oil tanker sits lower in the water than an empty one. Why?

Got questions? Get instant answers now!

Is surface tension due to cohesive or adhesive forces, or both?

Got questions? Get instant answers now!

Is capillary action due to cohesive or adhesive forces, or both?

Got questions? Get instant answers now!

Birds such as ducks, geese, and swans have greater densities than water, yet they are able to sit on its surface. Explain this ability, noting that water does not wet their feathers and that they cannot sit on soapy water.

Got questions? Get instant answers now!

Water beads up on an oily sunbather, but not on her neighbor, whose skin is not oiled. Explain in terms of cohesive and adhesive forces.

Got questions? Get instant answers now!

Could capillary action be used to move fluids in a “weightless” environment, such as in an orbiting space probe?

Got questions? Get instant answers now!

What effect does capillary action have on the reading of a manometer with uniform diameter? Explain your answer.

Got questions? Get instant answers now!

Pressure between the inside chest wall and the outside of the lungs normally remains negative. Explain how pressure inside the lungs can become positive (to cause exhalation) without muscle action.

Got questions? Get instant answers now!

Problems&Exercises

What is the pressure inside an alveolus having a radius of 2 . 50 × 10 4 m size 12{2 "." "50" times "10" rSup { size 8{ - 4} } `m} {} if the surface tension of the fluid-lined wall is the same as for soapy water? You may assume the pressure is the same as that created by a spherical bubble.

592 N/m 2 size 12{"592"`"N/m" rSup { size 8{2} } } {}

Got questions? Get instant answers now!

(a) The pressure inside an alveolus with a 2 . 00 × 10 4 size 12{2 "." "00" times "10" rSup { size 8{ - 4} } } {} -m radius is 1 . 40 × 10 3 Pa size 12{1 "." "40" times "10" rSup { size 8{3} } `"Pa"} {} , due to its fluid-lined walls. Assuming the alveolus acts like a spherical bubble, what is the surface tension of the fluid? (b) Identify the likely fluid. (You may need to extrapolate between values in [link] .)

Got questions? Get instant answers now!

What is the gauge pressure in millimeters of mercury inside a soap bubble 0.100 m in diameter?

2 . 23 × 10 2 mm Hg size 12{2 "." "23" times "10" rSup { size 8{ - 2} } `"mm"`"Hg"} {}

Got questions? Get instant answers now!

Calculate the force on the slide wire in [link] if it is 3.50 cm long and the fluid is ethyl alcohol.

Got questions? Get instant answers now!

[link] (a) shows the effect of tube radius on the height to which capillary action can raise a fluid. (a) Calculate the height h size 12{h} {} for water in a glass tube with a radius of 0.900 cm—a rather large tube like the one on the left. (b) What is the radius of the glass tube on the right if it raises water to 4.00 cm?

(a) 1 . 65 × 10 3 m size 12{1 "." "65" times "10" rSup { size 8{ - 3} } `m} {}

(b) 3 . 71 × 10 –4 m size 12{3 "." "71" times "10" rSup { size 8{4} } `m} {}

Got questions? Get instant answers now!

We stated in [link] that a xylem tube is of radius 2 . 50 × 10 5 m . Verify that such a tube raises sap less than a meter by finding h for it, making the same assumptions that sap’s density is 1050 kg/m 3 size 12{"1050"`"kg/m" rSup { size 8{3} } } {} , its contact angle is zero, and its surface tension is the same as that of water at 20.0º C .

Got questions? Get instant answers now!

What fluid is in the device shown in [link] if the force is 3 . 16 × 10 3 N size 12{3 "." "16" times "10" rSup { size 8{ - 3} } `N} {} and the length of the wire is 2.50 cm? Calculate the surface tension γ size 12{g} {} and find a likely match from [link] .

6 . 32 × 10 2 N/m size 12{6 "." "32" times "10" rSup { size 8{ - 2} } `"N/m"} {}

Based on the values in table, the fluid is probably glycerin.

Got questions? Get instant answers now!

If the gauge pressure inside a rubber balloon with a 10.0-cm radius is 1.50 cm of water, what is the effective surface tension of the balloon?

Got questions? Get instant answers now!

Calculate the gauge pressures inside 2.00-cm-radius bubbles of water, alcohol, and soapy water. Which liquid forms the most stable bubbles, neglecting any effects of evaporation?

P w = 14 . 6 N/m 2 , P a = 4.46 N/m 2 , P sw = 7.40 N/m 2 . alignl { stack { size 12{P rSub { size 8{w} } ="14" "." 6`"N/m" rSup { size 8{2} } , } {} #p rSub { size 8{a} } =4 "." "46"`"N/m" rSup { size 8{2} } , {} #P rSub { size 8{"sw"} } =7 "." "40"`"N/m" rSup { size 8{2} } "." {} } } {}

Alcohol forms the most stable bubble, since the absolute pressure inside is closest to atmospheric pressure.

Got questions? Get instant answers now!

Suppose water is raised by capillary action to a height of 5.00 cm in a glass tube. (a) To what height will it be raised in a paraffin tube of the same radius? (b) In a silver tube of the same radius?

Got questions? Get instant answers now!

Calculate the contact angle θ size 12{θ} {} for olive oil if capillary action raises it to a height of 7.07 cm in a glass tube with a radius of 0.100 mm. Is this value consistent with that for most organic liquids?

5.1º size 12{5 "." 1°} {}

This is near the value of θ = size 12{θ=0°} {} for most organic liquids.

Got questions? Get instant answers now!

When two soap bubbles touch, the larger is inflated by the smaller until they form a single bubble. (a) What is the gauge pressure inside a soap bubble with a 1.50-cm radius? (b) Inside a 4.00-cm-radius soap bubble? (c) Inside the single bubble they form if no air is lost when they touch?

Got questions? Get instant answers now!

Calculate the ratio of the heights to which water and mercury are raised by capillary action in the same glass tube.

2 . 78 size 12{ - 2 "." "78"} {}

The ratio is negative because water is raised whereas mercury is lowered.

Got questions? Get instant answers now!

What is the ratio of heights to which ethyl alcohol and water are raised by capillary action in the same glass tube?

Got questions? Get instant answers now!

Questions & Answers

it is the relatively stable flow of income
Chidubem Reply
what is circular flow of income
Divine Reply
branches of macroeconomics
SHEDRACK Reply
what is Flexible exchang rate?
poudel Reply
is gdp a reliable measurement of wealth
Atega Reply
introduction to econometrics
Husseini Reply
Hi
mostafa
hi
LEMLEM
hello
Sammol
hi
Mahesh
bi
Ruqayat
hi
Ruqayat
Hi fellas
Nyawa
hey
Sammol
hi
God
hello
Jahara
Good morning
Jorge
hi
abubakar
hi
Nmesoma
hi
Mahesh
Hi
Tom
Why is unemployment rate never zero at full employment?
Priyanka Reply
bcoz of existence of frictional unemployment in our economy.
Umashankar
what is flexible exchang rate?
poudel
due to existence of the pple with disabilities
Abdulraufu
the demand of a good rises, causing the demand for another good to fall
Rushawn Reply
is it possible to leave every good at the same level
Joseph
I don't think so. because check it, if the demand for chicken increases, people will no longer consume fish like they used to causing a fall in the demand for fish
Anuolu
is not really possible to let the value of a goods to be same at the same time.....
Salome
Suppose the inflation rate is 6%, does it mean that all the goods you purchase will cost 6% more than previous year? Provide with reasoning.
Geetha Reply
Not necessarily. To measure the inflation rate economists normally use an averaged price index of a basket of certain goods. So if you purchase goods included in the basket, you will notice that you pay 6% more, otherwise not necessarily.
Waeth
discus major problems of macroeconomics
Alii Reply
what is the problem of macroeconomics
Yoal
Economic growth Stable prices and low unemployment
Ephraim
explain inflationcause and itis degre
Miresa Reply
what is inflation
Getu
increase in general price levels
WEETO
Good day How do I calculate this question: C= 100+5yd G= 2000 T= 2000 I(planned)=200. Suppose the actual output is 3000. What is the level of planned expenditures at this level of output?
Chisomo Reply
how to calculate actual output?
Chisomo
how to calculate the equilibrium income
Beshir
Criteria for determining money supply
Thapase Reply
who we can define macroeconomics in one line
Muhammad
Aggregate demand
Mohammed
C=k100 +9y and i=k50.calculate the equilibrium level of output
Mercy Reply
Hi
Isiaka
Hi
Geli
hy
Man
👋
Bahunda
hy how are you?
Man
ys
Amisha
how are you guys
Sekou
f9 guys
Amisha
how are you guys
Sekou
ys am also fine
Amisha
fine and you guys
Geli
from Nepal
Amisha
nawalparasi district from belatari
Amisha
nd u
Amisha
I am Camara from Guinea west Africa... happy to meet you guys here
Sekou
ma management ho
Amisha
ahile becheclor ho
Amisha
hjr ktm bta ho ani k kaam grnu hunxa tw
Amisha
belatari
Amisha
1st year ho
Amisha
nd u
Amisha
ahh
Amisha
kaha biratnagar
Amisha
ys
Amisha
kina k vo
Amisha
money as unit of account means what?
Kalombe
A unit of account is something that can be used to value goods and services and make calculations
Jim
all of you please speak in English I can't understand you're language
Muhammad
I want to know how can we define macroeconomics in one line
Muhammad
it must be .9 or 0.9 no Mpc is greater than 1 Y=100+.9Y+50 Y-.9Y=150 0.1Y/0.1=150/0.1 Y=1500
Kalombe
Mercy is it clear?😋
Kalombe
hi can someone help me on this question If a negative shocks shifts the IS curve to the left, what type of policy do you suggest so as to stabilize the level of output? discuss your answer using appropriate graph.
Galge Reply
if interest rate is increased this will will reduce the level of income shifting the curve to the left ◀️
Kalombe
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 5

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, College physics. OpenStax CNX. Jul 27, 2015 Download for free at http://legacy.cnx.org/content/col11406/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'College physics' conversation and receive update notifications?

Ask