<< Chapter < Page Chapter >> Page >
  • Calculate the impedance, phase angle, resonant frequency, power, power factor, voltage, and/or current in a RLC series circuit.
  • Draw the circuit diagram for an RLC series circuit.
  • Explain the significance of the resonant frequency.

Impedance

When alone in an AC circuit, inductors, capacitors, and resistors all impede current. How do they behave when all three occur together? Interestingly, their individual resistances in ohms do not simply add. Because inductors and capacitors behave in opposite ways, they partially to totally cancel each other’s effect. [link] shows an RLC series circuit with an AC voltage source, the behavior of which is the subject of this section. The crux of the analysis of an RLC circuit is the frequency dependence of X L size 12{X rSub { size 8{L} } } {} and X C size 12{X rSub { size 8{C} } } {} , and the effect they have on the phase of voltage versus current (established in the preceding section). These give rise to the frequency dependence of the circuit, with important “resonance” features that are the basis of many applications, such as radio tuners.

The figure describes an R LC series circuit. It shows a resistor R connected in series with an inductor L, connected to a capacitor C in series to an A C source V. The voltage of the A C source is given by V equals V zero sine two pi f t. The voltage across R is V R, across L is V L and across C is V C.
An RLC series circuit with an AC voltage source.

The combined effect of resistance R size 12{R} {} , inductive reactance X L size 12{X rSub { size 8{L} } } {} , and capacitive reactance X C size 12{X rSub { size 8{C} } } {} is defined to be impedance    , an AC analogue to resistance in a DC circuit. Current, voltage, and impedance in an RLC circuit are related by an AC version of Ohm’s law:

I 0 = V 0 Z or I rms = V rms Z . size 12{I rSub { size 8{0} } = { {V rSub { size 8{0} } } over {Z} } " or "I rSub { size 8{ ital "rms"} } = { {V rSub { size 8{ ital "rms"} } } over {Z} } "." } {}

Here I 0 size 12{I rSub { size 8{0} } } {} is the peak current, V 0 size 12{V rSub { size 8{0} } } {} the peak source voltage, and Z is the impedance of the circuit. The units of impedance are ohms, and its effect on the circuit is as you might expect: the greater the impedance, the smaller the current. To get an expression for Z size 12{Z} {} in terms of R , X L size 12{X rSub { size 8{L} } } {} , and X C size 12{X rSub { size 8{C} } } {} , we will now examine how the voltages across the various components are related to the source voltage. Those voltages are labeled V R size 12{V rSub { size 8{R} } } {} , V L size 12{V rSub { size 8{L} } } {} , and V C size 12{V rSub { size 8{C} } } {} in [link] .

Conservation of charge requires current to be the same in each part of the circuit at all times, so that we can say the currents in R size 12{R} {} , L size 12{L} {} , and C size 12{C} {} are equal and in phase. But we know from the preceding section that the voltage across the inductor V L size 12{V rSub { size 8{L} } } {} leads the current by one-fourth of a cycle, the voltage across the capacitor V C size 12{V rSub { size 8{C} } } {} follows the current by one-fourth of a cycle, and the voltage across the resistor V R size 12{V rSub { size 8{R} } } {} is exactly in phase with the current. [link] shows these relationships in one graph, as well as showing the total voltage around the circuit V = V R + V L + V C size 12{V=V rSub { size 8{R} } +V rSub { size 8{L} } +V rSub { size 8{C} } } {} , where all four voltages are the instantaneous values. According to Kirchhoff’s loop rule, the total voltage around the circuit V is also the voltage of the source.

You can see from [link] that while V R size 12{V rSub { size 8{R} } } {} is in phase with the current, V L size 12{V rSub { size 8{L} } } {} leads by 90º , and V C size 12{V rSub { size 8{C} } } {} follows by 90º . Thus V L size 12{V rSub { size 8{L} } } {} and V C size 12{V rSub { size 8{C} } } {} are 180º out of phase (crest to trough) and tend to cancel, although not completely unless they have the same magnitude. Since the peak voltages are not aligned (not in phase), the peak voltage V 0 size 12{V rSub { size 8{0} } } {} of the source does not equal the sum of the peak voltages across R size 12{R} {} , L size 12{L} {} , and C size 12{C} {} . The actual relationship is

V 0 = V 0 R 2 + ( V 0 L V 0 C ) 2 , size 12{V rSub { size 8{0} } = sqrt {V rSub { size 8{0R} } "" lSup { size 8{2} } + \( V rSub { size 8{0L} } - V rSub { size 8{0C} } \) rSup { size 8{2} } } ,} {}

where V 0 R size 12{V rSub { size 8{0R} } } {} , V 0 L size 12{V rSub { size 8{0L} } } {} , and V 0 C size 12{V rSub { size 8{0C} } } {} are the peak voltages across R size 12{R} {} , L size 12{L} {} , and C size 12{C} {} , respectively. Now, using Ohm’s law and definitions from Reactance, Inductive and Capacitive , we substitute V 0 = I 0 Z size 12{V rSub { size 8{0} } =I rSub { size 8{0} } Z} {} into the above, as well as V 0 R = I 0 R size 12{V rSub { size 8{0R} } =I rSub { size 8{0} } R} {} , V 0 L = I 0 X L size 12{V rSub { size 8{0L} } =I rSub { size 8{0} } X rSub { size 8{L} } } {} , and V 0 C = I 0 X C size 12{V rSub { size 8{0C} } =I rSub { size 8{0} } X rSub { size 8{C} } } {} , yielding

Questions & Answers

A golfer on a fairway is 70 m away from the green, which sits below the level of the fairway by 20 m. If the golfer hits the ball at an angle of 40° with an initial speed of 20 m/s, how close to the green does she come?
Aislinn Reply
cm
tijani
what is titration
John Reply
what is physics
Siyaka Reply
A mouse of mass 200 g falls 100 m down a vertical mine shaft and lands at the bottom with a speed of 8.0 m/s. During its fall, how much work is done on the mouse by air resistance
Jude Reply
Can you compute that for me. Ty
Jude
what is the dimension formula of energy?
David Reply
what is viscosity?
David
what is inorganic
emma Reply
what is chemistry
Youesf Reply
what is inorganic
emma
Chemistry is a branch of science that deals with the study of matter,it composition,it structure and the changes it undergoes
Adjei
please, I'm a physics student and I need help in physics
Adjanou
chemistry could also be understood like the sexual attraction/repulsion of the male and female elements. the reaction varies depending on the energy differences of each given gender. + masculine -female.
Pedro
A ball is thrown straight up.it passes a 2.0m high window 7.50 m off the ground on it path up and takes 1.30 s to go past the window.what was the ball initial velocity
Krampah Reply
2. A sled plus passenger with total mass 50 kg is pulled 20 m across the snow (0.20) at constant velocity by a force directed 25° above the horizontal. Calculate (a) the work of the applied force, (b) the work of friction, and (c) the total work.
Sahid Reply
you have been hired as an espert witness in a court case involving an automobile accident. the accident involved car A of mass 1500kg which crashed into stationary car B of mass 1100kg. the driver of car A applied his brakes 15 m before he skidded and crashed into car B. after the collision, car A s
Samuel Reply
can someone explain to me, an ignorant high school student, why the trend of the graph doesn't follow the fact that the higher frequency a sound wave is, the more power it is, hence, making me think the phons output would follow this general trend?
Joseph Reply
Nevermind i just realied that the graph is the phons output for a person with normal hearing and not just the phons output of the sound waves power, I should read the entire thing next time
Joseph
Follow up question, does anyone know where I can find a graph that accuretly depicts the actual relative "power" output of sound over its frequency instead of just humans hearing
Joseph
"Generation of electrical energy from sound energy | IEEE Conference Publication | IEEE Xplore" ***ieeexplore.ieee.org/document/7150687?reload=true
Ryan
what's motion
Maurice Reply
what are the types of wave
Maurice
answer
Magreth
progressive wave
Magreth
hello friend how are you
Muhammad Reply
fine, how about you?
Mohammed
hi
Mujahid
A string is 3.00 m long with a mass of 5.00 g. The string is held taut with a tension of 500.00 N applied to the string. A pulse is sent down the string. How long does it take the pulse to travel the 3.00 m of the string?
yasuo Reply
Who can show me the full solution in this problem?
Reofrir Reply
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 4

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, College physics. OpenStax CNX. Jul 27, 2015 Download for free at http://legacy.cnx.org/content/col11406/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'College physics' conversation and receive update notifications?

Ask