<< Chapter < Page Chapter >> Page >
  • Describe uniform circular motion.
  • Explain non-uniform circular motion.
  • Calculate angular acceleration of an object.
  • Observe the link between linear and angular acceleration.

Uniform Circular Motion and Gravitation discussed only uniform circular motion, which is motion in a circle at constant speed and, hence, constant angular velocity. Recall that angular velocity ω size 12{ω} {} was defined as the time rate of change of angle θ size 12{θ} {} :

ω = Δ θ Δ t , size 12{ω= { {Δθ} over {Δt} } ","} {}

where θ size 12{θ} {} is the angle of rotation as seen in [link] . The relationship between angular velocity ω size 12{ω} {} and linear velocity v size 12{v} {} was also defined in Rotation Angle and Angular Velocity as

v = size 12{v=rω} {}

or

ω = v r , size 12{ω= { {v} over {r} } } {}

where r size 12{r} {} is the radius of curvature, also seen in [link] . According to the sign convention, the counter clockwise direction is considered as positive direction and clockwise direction as negative

The given figure shows counterclockwise circular motion with a horizontal line, depicting radius r, drawn from the center of the circle to the right side on its circumference and another line is drawn in such a manner that it makes an acute angle delta theta with the horizontal line. Tangential velocity vectors are indicated at the end of the two lines. At the bottom right side of the figure, the formula for angular velocity is given as v upon r.
This figure shows uniform circular motion and some of its defined quantities.

Angular velocity is not constant when a skater pulls in her arms, when a child starts up a merry-go-round from rest, or when a computer’s hard disk slows to a halt when switched off. In all these cases, there is an angular acceleration    , in which ω size 12{ω} {} changes. The faster the change occurs, the greater the angular acceleration. Angular acceleration α size 12{α} {} is defined as the rate of change of angular velocity. In equation form, angular acceleration is expressed as follows:

α = Δ ω Δ t , size 12{α= { {Δω} over {Δt} } ","} {}

where Δ ω size 12{Δω} {} is the change in angular velocity    and Δ t size 12{Δt} {} is the change in time. The units of angular acceleration are rad/s /s size 12{ left ("rad/s" right )"/s"} {} , or rad/s 2 size 12{"rad/s" rSup { size 8{2} } } {} . If ω size 12{ω} {} increases, then α size 12{α} {} is positive. If ω size 12{ω} {} decreases, then α size 12{α} {} is negative.

Calculating the angular acceleration and deceleration of a bike wheel

Suppose a teenager puts her bicycle on its back and starts the rear wheel spinning from rest to a final angular velocity of 250 rpm in 5.00 s. (a) Calculate the angular acceleration in rad/s 2 size 12{"rad/s" rSup { size 8{2} } } {} . (b) If she now slams on the brakes, causing an angular acceleration of 87.3 rad/s 2 size 12{"-87" "." 3`"rad/s" rSup { size 8{2} } } {} , how long does it take the wheel to stop?

Strategy for (a)

The angular acceleration can be found directly from its definition in α = Δ ω Δ t size 12{α= { {Δω} over {Δt} } } {} because the final angular velocity and time are given. We see that Δ ω size 12{Δω} {} is 250 rpm and Δ t size 12{Δt} {} is 5.00 s.

Solution for (a)

Entering known information into the definition of angular acceleration, we get

α = Δ ω Δ t = 250 rpm 5.00 s . alignl { stack { size 12{α= { {Δω} over {Δt} } } {} #size 12{ {}= { {"250"" rpm"} over {5 "." "00 s"} } "."} {} } } {}

Because Δ ω size 12{Δω} {} is in revolutions per minute (rpm) and we want the standard units of rad/s 2 size 12{"rad/s" rSup { size 8{2} } } {} for angular acceleration, we need to convert Δ ω size 12{Δω} {} from rpm to rad/s:

Δ ω = 250 rev min 2π rad rev 1 min 60 sec = 26.2 rad s . alignl { stack { size 12{Δω="250" { {"rev"} over {"min"} } cdot { {2π" rad"} over {"60" "." "0 s"} } } {} #size 12{ {}="26" "." 2 { {"rad"} over {"s"} } } {} } } {}

Entering this quantity into the expression for α size 12{α} {} , we get

α = Δ ω Δ t = 26.2 rad/s 5.00 s = 5.24  rad/s 2 . alignl { stack { size 12{α= { {Δω} over {Δt} } } {} #size 12{ {}= { {"26" "." 2" rad/s"} over {5 "." "00"" s"} } "." } {} # size 12{ {}=5 "." "24"" rad/s" rSup { size 8{2} } } {}} } {}

Strategy for (b)

In this part, we know the angular acceleration and the initial angular velocity. We can find the stoppage time by using the definition of angular acceleration and solving for Δ t size 12{Δt} {} , yielding

Δ t = Δ ω α . size 12{Δt= { {Δω} over {α} } "."} {}

Solution for (b)

Here the angular velocity decreases from 26.2 rad/s size 12{"26" "." 2`"rad/s"} {} (250 rpm) to zero, so that Δ ω size 12{Δω} {} is 26.2 rad/s , and α size 12{α} {} is given to be 87.3 rad/s 2 size 12{"-87" "." 3`"rad/s" rSup { size 8{2} } } {} . Thus,

Δ t = 26.2 rad/s 87.3 rad/s 2 = 0.300 s. alignl { stack { size 12{Δt= { { - "26" "." 2`"rad/s"} over { - "87" "." 3`"rad/s" rSup { size 8{2} } } } } {} #=0 "." "300"`"s" "." {} } } {}

Discussion

Note that the angular acceleration as the girl spins the wheel is small and positive; it takes 5 s to produce an appreciable angular velocity. When she hits the brake, the angular acceleration is large and negative. The angular velocity quickly goes to zero. In both cases, the relationships are analogous to what happens with linear motion. For example, there is a large deceleration when you crash into a brick wall—the velocity change is large in a short time interval.

Got questions? Get instant answers now!

Questions & Answers

if three forces F1.f2 .f3 act at a point on a Cartesian plane in the daigram .....so if the question says write down the x and y components ..... I really don't understand
Syamthanda Reply
hey , can you please explain oxidation reaction & redox ?
Boitumelo Reply
hey , can you please explain oxidation reaction and redox ?
Boitumelo
for grade 12 or grade 11?
Sibulele
the value of V1 and V2
Tumelo Reply
advantages of electrons in a circuit
Rethabile Reply
we're do you find electromagnetism past papers
Ntombifuthi
what a normal force
Tholulwazi Reply
it is the force or component of the force that the surface exert on an object incontact with it and which acts perpendicular to the surface
Sihle
what is physics?
Petrus Reply
what is the half reaction of Potassium and chlorine
Anna Reply
how to calculate coefficient of static friction
Lisa Reply
how to calculate static friction
Lisa
How to calculate a current
Tumelo
how to calculate the magnitude of horizontal component of the applied force
Mogano
How to calculate force
Monambi
a structure of a thermocouple used to measure inner temperature
Anna Reply
a fixed gas of a mass is held at standard pressure temperature of 15 degrees Celsius .Calculate the temperature of the gas in Celsius if the pressure is changed to 2×10 to the power 4
Amahle Reply
How is energy being used in bonding?
Raymond Reply
what is acceleration
Syamthanda Reply
a rate of change in velocity of an object whith respect to time
Khuthadzo
how can we find the moment of torque of a circular object
Kidist
Acceleration is a rate of change in velocity.
Justice
t =r×f
Khuthadzo
how to calculate tension by substitution
Precious Reply
hi
Shongi
hi
Leago
use fnet method. how many obects are being calculated ?
Khuthadzo
khuthadzo hii
Hulisani
how to calculate acceleration and tension force
Lungile Reply
you use Fnet equals ma , newtoms second law formula
Masego
please help me with vectors in two dimensions
Mulaudzi Reply
how to calculate normal force
Mulaudzi
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 3

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, College physics. OpenStax CNX. Jul 27, 2015 Download for free at http://legacy.cnx.org/content/col11406/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'College physics' conversation and receive update notifications?

Ask