<< Chapter < Page Chapter >> Page >

Suspensions are vitally important to the texture of Renaissance music. The suspended note must receive slightly more emphasis than its resolution. A conductor should avoid telling a choir to accent this note. The suspended note can be stressed with a slight growth in the tone.

Although long known as a great era of a cappella singing, instruments were used frequently to augment the singers or to double the voice parts. The use of instruments was left to the discretion of the performers. Present conductors must make the same decision except that this decision is hampered by a lack of knowledge of performance practice of the period. As a general rule one can be freer in the use of instruments in secular music than in sacred. The liturgy also prohibited use of instruments at certain times during the church year.

The acoustics of the performing hall will also play a part not only in the tempo of the work, but in the manner in which the polyphonic motet, for instance, should be performed. A very live hall will necessitate a very cautious control of dynamics and of tone. The most subtle shading, already being carefully managed, will be magnified under extremely live acoustical conditions. A slightly slower tempo may often be used to avoid a blurring of the points of imitation and cadences. A very dead, or dry hall, on the other hand, will require some increases in volume to compensate for the lack of reverberation, and often a slightly faster tempo.

Tone quality

The nature of music of the Renaissance, specifically the polyphony, requires a tone quality with a minimal amount of vibrato and one that is well focused. Excessive vibrato creates a tone quality that prevents the polyphony from being clear. Again, authenticity is not completely possible and probably not completely desirable, if it were possible. We are different people in a different time with different tonal expectations. It is not necessary to completely remove the vibrato from the tone to successfully perform Renaissance music. It is necessary to be certain that the tone is well focused and that the vibrato is minimal with considerable attention to the melodic qualities and independence of each part.

We cannot be certain of the tone quality of singers during the Renaissance. We know that women did not sing the soprano and alto parts, and that the boy's voice was smaller, not as rich, and probably had less vibrato than a woman's voice. Indications from a variety of sources are that vibrato was not the tonal ideal of the period. We also know that the churches and cathedrals had an effect on the tone, and that our performing halls differ so greatly around the country that comparisons are impossible.

To create, or attempt to create, an "authentic" performance of this music is obviously impossible. Conductors will be successful by being faithful to the import of the score, by allowing the polyphony to be clear, unhampered, with attention to each independent vocal line.

Renaissance composers

John Dunstable (c. 1385-1453)

Gilles Binchois (c. 1400-1460)

Guillaume Dufay (c. 1400-1474)

Johannes Okeghem (c. 1420-1495)

Jacob Obrecht (c. 1453-1505)

Heinrich Isaac (c. 1450-1517)

Josquin Des Prez (c. 1450-1521)

Jean Mouton (c. 1470-1522)

Thomas Tallis (c. 1505-1585)

Jacob Arcadelt (c. 1510-1567)

Andrea Gabrieli (c. 1510-1586)

G. P. Palestrina (c. 1525-1594)

Richard Farrant (c. 1530-1580)

Orlando di Lasso (Roland de Lassus) (c. 1532-1594)

William Byrd (c. 1543-1623)

Tomas Luis de Victoria (c. 1549-1611)

Jacobus Gallus (Jacob Handl) (c. 1550-1611)

Orazio Vecchi (c. 1550-1605)

Luca Merenzio (c. 1553-1599)

Thomas Morley (c. 1557-1603)

Carlo Gesualdo (c. 1560-1613)

John Dowland (c. 1562-1626)

Hans Leo Hassler (c. 1564-1612)

John Wilbye (c. 1574-1638)

Thomas Weelkes (c. 1575-1638)

Orlando Gibbons (c. 1583-1625)

Suggested works for study

O Vos Omnes, Esquivel (G. Schirmer 11231)

Domine Exaudi Deus Orationem, di Lasso (G. Schirmer 11422)

Magnificat in Primi Toni, Palestrina (Lawson-Gould)

O Magnum Mysterium, Victoria (G. Schirmer 7626)

O Quam Gloriosum, Victoria (G. Schirmer 13448)

Call to Remembrance, Farrant (Bourne ES 17)

Ave Maria, Mouton (Mercury Music DCS-40)

Jubilate Deo, di Lasso (Boosey and Hawkes 5490)

Tu Pauperum Refugium, Josquin (G. Schirmer 9565)

Questions & Answers

Three charges q_{1}=+3\mu C, q_{2}=+6\mu C and q_{3}=+8\mu C are located at (2,0)m (0,0)m and (0,3) coordinates respectively. Find the magnitude and direction acted upon q_{2} by the two other charges.Draw the correct graphical illustration of the problem above showing the direction of all forces.
Kate Reply
To solve this problem, we need to first find the net force acting on charge q_{2}. The magnitude of the force exerted by q_{1} on q_{2} is given by F=\frac{kq_{1}q_{2}}{r^{2}} where k is the Coulomb constant, q_{1} and q_{2} are the charges of the particles, and r is the distance between them.
Muhammed
What is the direction and net electric force on q_{1}= 5µC located at (0,4)r due to charges q_{2}=7mu located at (0,0)m and q_{3}=3\mu C located at (4,0)m?
Kate Reply
what is the change in momentum of a body?
Eunice Reply
what is a capacitor?
Raymond Reply
Capacitor is a separation of opposite charges using an insulator of very small dimension between them. Capacitor is used for allowing an AC (alternating current) to pass while a DC (direct current) is blocked.
Gautam
A motor travelling at 72km/m on sighting a stop sign applying the breaks such that under constant deaccelerate in the meters of 50 metres what is the magnitude of the accelerate
Maria Reply
please solve
Sharon
8m/s²
Aishat
What is Thermodynamics
Muordit
velocity can be 72 km/h in question. 72 km/h=20 m/s, v^2=2.a.x , 20^2=2.a.50, a=4 m/s^2.
Mehmet
A boat travels due east at a speed of 40meter per seconds across a river flowing due south at 30meter per seconds. what is the resultant speed of the boat
Saheed Reply
50 m/s due south east
Someone
which has a higher temperature, 1cup of boiling water or 1teapot of boiling water which can transfer more heat 1cup of boiling water or 1 teapot of boiling water explain your . answer
Ramon Reply
I believe temperature being an intensive property does not change for any amount of boiling water whereas heat being an extensive property changes with amount/size of the system.
Someone
Scratch that
Someone
temperature for any amount of water to boil at ntp is 100⁰C (it is a state function and and intensive property) and it depends both will give same amount of heat because the surface available for heat transfer is greater in case of the kettle as well as the heat stored in it but if you talk.....
Someone
about the amount of heat stored in the system then in that case since the mass of water in the kettle is greater so more energy is required to raise the temperature b/c more molecules of water are present in the kettle
Someone
definitely of physics
Haryormhidey Reply
how many start and codon
Esrael Reply
what is field
Felix Reply
physics, biology and chemistry this is my Field
ALIYU
field is a region of space under the influence of some physical properties
Collete
what is ogarnic chemistry
WISDOM Reply
determine the slope giving that 3y+ 2x-14=0
WISDOM
Another formula for Acceleration
Belty Reply
a=v/t. a=f/m a
IHUMA
innocent
Adah
pratica A on solution of hydro chloric acid,B is a solution containing 0.5000 mole ofsodium chlorid per dm³,put A in the burret and titrate 20.00 or 25.00cm³ portion of B using melting orange as the indicator. record the deside of your burret tabulate the burret reading and calculate the average volume of acid used?
Nassze Reply
how do lnternal energy measures
Esrael
Two bodies attract each other electrically. Do they both have to be charged? Answer the same question if the bodies repel one another.
JALLAH Reply
No. According to Isac Newtons law. this two bodies maybe you and the wall beside you. Attracting depends on the mass och each body and distance between them.
Dlovan
Are you really asking if two bodies have to be charged to be influenced by Coulombs Law?
Robert
like charges repel while unlike charges atttact
Raymond
What is specific heat capacity
Destiny Reply
Specific heat capacity is a measure of the amount of energy required to raise the temperature of a substance by one degree Celsius (or Kelvin). It is measured in Joules per kilogram per degree Celsius (J/kg°C).
AI-Robot
specific heat capacity is the amount of energy needed to raise the temperature of a substance by one degree Celsius or kelvin
ROKEEB
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Music appreciation. OpenStax CNX. Mar 24, 2014 Download for free at http://cnx.org/content/col11640/1.1
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Music appreciation' conversation and receive update notifications?

Ask