<< Chapter < Page Chapter >> Page >

Catching speeders with radar

RU Electronics has been contracted to design a Doppler radar system. Radar transmitters emit a signal that bounces off any conducting object.Signal differences between what is sent and the radar return is processed and features of interest extracted. In Doppler systems, the object's speed along the direction of the radar beam is the feature the design must extract. The transmitted signal is a sinsusoid: x t A 2 f c t . The measured return signal equals B 2 f c Δf t ϕ , where the Doppler offset frequency Δf equals 10 v , where v is the car's velocity coming toward the transmitter.

  1. Design a system that uses the transmitted and return signals as inputs and produces Δf .
  2. One problem with designs based on overly simplistic design goals is that they are sensitive to unmodeled assumptions. How would you change your design, if at all, so that whether the car is going away or toward the transmitter could be determined?
  3. Suppose two objects traveling different speeds provide returns. How would you change your design, if at all, to accomodate multiple returns?

Demodulating an am signal

Let m t denote the signal that has been amplitude modulated. x t A 1 m t 2 f c t Radio stations try to restrict the amplitude of thesignal m t so that it is less than one in magnitude. The frequency f c is very large compared to the frequency content of the signal. What we are concerned about here is nottransmission, but reception.

  1. The so-called coherent demodulator simply multiplies the signal x t by a sinusoid having the same frequency as thecarrier and lowpass filters the result. Analyze this receiver and show that it works. Assume thelowpass filter is ideal.
  2. One issue in coherent reception is the phase of the sinusoid used by the receiver relative to that usedby the transmitter. Assuming that the sinusoid of the receiver has a phase φ , how does the output depend on φ ? What is the worst possible value for this phase?
  3. The incoherent receiver is more commonly used because of the phase sensitivity problem inherent incoherent reception. Here, the receiver full-wave rectifies the received signal and lowpass filtersthe result (again ideally). Analyze this receiver. Does its output differ from that of the coherentreceiver in a significant way?

Unusual amplitude modulation

We want to send a band-limited signal having the depicted spectrum with amplitude modulation in the usual way. I.B. Different suggests using the square-wave carrier shown below . Well, it is different, but his friends wonder if any technique can demodulate it.

  1. Find an expression for X f , the Fourier transform of the modulated signal.
  2. Sketch the magnitude of X f , being careful to label important magnitudes and frequencies.
  3. What demodulation technique obviously works?
  4. I.B. challenges three of his friends to demodulate x t some other way. One friend suggests modulating x t with t 2 , another wants to try modulating with t and the third thinks 3 t 2 will work. Sketch the magnitude of the Fourier transform of the signal each student's approach produces.Which student comes closest to recovering the original signal? Why?

Questions & Answers

calculate molarity of NaOH solution when 25.0ml of NaOH titrated with 27.2ml of 0.2m H2SO4
Gasin Reply
what's Thermochemistry
rhoda Reply
the study of the heat energy which is associated with chemical reactions
Kaddija
How was CH4 and o2 was able to produce (Co2)and (H2o
Edafe Reply
explain please
Victory
First twenty elements with their valences
Martine Reply
what is chemistry
asue Reply
what is atom
asue
what is the best way to define periodic table for jamb
Damilola Reply
what is the change of matter from one state to another
Elijah Reply
what is isolation of organic compounds
IKyernum Reply
what is atomic radius
ThankGod Reply
Read Chapter 6, section 5
Dr
Read Chapter 6, section 5
Kareem
Atomic radius is the radius of the atom and is also called the orbital radius
Kareem
atomic radius is the distance between the nucleus of an atom and its valence shell
Amos
Read Chapter 6, section 5
paulino
Bohr's model of the theory atom
Ayom Reply
is there a question?
Dr
when a gas is compressed why it becomes hot?
ATOMIC
It has no oxygen then
Goldyei
read the chapter on thermochemistry...the sections on "PV" work and the First Law of Thermodynamics should help..
Dr
Which element react with water
Mukthar Reply
Mgo
Ibeh
an increase in the pressure of a gas results in the decrease of its
Valentina Reply
definition of the periodic table
Cosmos Reply
What is the lkenes
Da Reply
what were atoms composed of?
Moses Reply
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Fundamentals of electrical engineering i. OpenStax CNX. Aug 06, 2008 Download for free at http://legacy.cnx.org/content/col10040/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Fundamentals of electrical engineering i' conversation and receive update notifications?

Ask