<< Chapter < Page Chapter >> Page >

Some common solubility products are listed in [link] according to their K sp values, whereas a more extensive compilation of products appears in Appendix J . Each of these equilibrium constants is much smaller than 1 because the compounds listed are only slightly soluble. A small K sp represents a system in which the equilibrium lies to the left, so that relatively few hydrated ions would be present in a saturated solution.

Common Solubility Products by Decreasing Equilibrium Constants
Substance K sp at 25 °C
CuCl 1.2 × 10 –6
CuBr 6.27 × 10 –9
AgI 1.5 × 10 –16
PbS 7 × 10 –29
Al(OH) 3 2 × 10 –32
Fe(OH) 3 4 × 10 –38

Writing equations and solubility products

Write the ionic equation for the dissolution and the solubility product expression for each of the following slightly soluble ionic compounds:

(a) AgI, silver iodide, a solid with antiseptic properties

(b) CaCO 3 , calcium carbonate, the active ingredient in many over-the-counter chewable antacids

(c) Mg(OH) 2 , magnesium hydroxide, the active ingredient in Milk of Magnesia

(d) Mg(NH 4 )PO 4 , magnesium ammonium phosphate, an essentially insoluble substance used in tests for magnesium

(e) Ca 5 (PO 4 ) 3 OH, the mineral apatite, a source of phosphate for fertilizers

(Hint: When determining how to break (d) and (e) up into ions, refer to the list of polyatomic ions in the section on chemical nomenclature.)

Solution

(a) AgI ( s ) Ag + ( a q ) + I ( a q ) K sp = [ Ag + ] [ I ]

(b) CaCO 3 ( s ) Ca 2+ ( a q ) + CO 3 2− ( a q ) K sp = [ Ca 2+ ] [ CO 3 2− ]

(c) Mg ( OH ) 2 ( s ) Mg 2+ ( a q ) + 2OH ( a q ) K sp = [ Mg 2+ ] [ OH ] 2

(d) Mg ( NH 4 ) PO 4 ( s ) Mg 2+ ( a q ) + NH 4 + ( a q ) + PO 4 3− ( a q ) K sp = [ Mg 2+ ] [ NH 4 + ] [ PO 4 3− ]

(e) Ca 5 ( PO 4 ) 3 OH ( s ) 5Ca 2+ ( a q ) + 3PO 4 3− ( a q ) + OH ( a q ) K sp = [ Ca 2+ ] 5 [ P O 4 3− ] 3 [ OH ]

Check your learning

Write the ionic equation for the dissolution and the solubility product for each of the following slightly soluble compounds:

(a) BaSO 4

(b) Ag 2 SO 4

(c) Al(OH) 3

(d) Pb(OH)Cl

Answer:

(a) BaSO 4 ( s ) Ba 2+ ( a q ) + SO 4 2− ( a q ) K sp = [ Ba 2+ ] [ SO 4 2 ] ; (b) Ag 2 SO 4 ( s ) 2Ag + ( a q ) + SO 4 2− ( a q ) K sp = [ Ag + ] 2 [ SO 4 2− ] ; (c) Al ( OH ) 3 ( s ) Al 2+ ( a q ) + 3OH ( a q ) K sp = [ Al 3+ ] [ OH ] 3 ; (d) Pb(OH)Cl( s ) Pb 2+ ( a q ) + OH ( a q ) + Cl ( a q ) K sp = [ Pb 2+ ] [ OH ] [ Cl ]

Got questions? Get instant answers now!

Now we will extend the discussion of K sp and show how the solubility product constant is determined from the solubility of its ions, as well as how K sp can be used to determine the molar solubility of a substance.

K sp And solubility

Recall that the definition of solubility is the maximum possible concentration of a solute in a solution at a given temperature and pressure. We can determine the solubility product of a slightly soluble solid from that measure of its solubility at a given temperature and pressure, provided that the only significant reaction that occurs when the solid dissolves is its dissociation into solvated ions, that is, the only equilibrium involved is:

M p X q ( s ) p M m+ ( a q ) + q X n− ( a q )

In this case, we calculate the solubility product by taking the solid’s solubility expressed in units of moles per liter (mol/L), known as its molar solubility    .

Calculation of K sp From equilibrium concentrations

We began the chapter with an informal discussion of how the mineral fluorite ( [link] ) is formed. Fluorite, CaF 2 , is a slightly soluble solid that dissolves according to the equation:

CaF 2 ( s ) Ca 2+ ( a q ) + 2F ( a q )

The concentration of Ca 2+ in a saturated solution of CaF 2 is 2.15 × 10 –4 M ; therefore, that of F is 4.30 × 10 –4 M , that is, twice the concentration of Ca 2+ . What is the solubility product of fluorite?

Solution

First, write out the K sp expression, then substitute in concentrations and solve for K sp :

CaF 2 ( s ) Ca 2+ ( a q ) + 2F ( a q )

A saturated solution is a solution at equilibrium with the solid. Thus:

K sp = [ Ca 2+ ] [ F ] 2 = (2.1 × 10 4 ) ( 4.2 × 10 4 ) 2 = 3.7 × 10 11

As with other equilibrium constants, we do not include units with K sp .

Check your learning

In a saturated solution that is in contact with solid Mg(OH) 2 , the concentration of Mg 2+ is 1.31 × 10 –4 M . What is the solubility product for Mg(OH) 2 ?

Mg(OH) 2 ( s ) Mg 2+ ( a q ) + 2OH ( a q )

Answer:

8.99 × 10 –12

Got questions? Get instant answers now!

Questions & Answers

Three charges q_{1}=+3\mu C, q_{2}=+6\mu C and q_{3}=+8\mu C are located at (2,0)m (0,0)m and (0,3) coordinates respectively. Find the magnitude and direction acted upon q_{2} by the two other charges.Draw the correct graphical illustration of the problem above showing the direction of all forces.
Kate Reply
To solve this problem, we need to first find the net force acting on charge q_{2}. The magnitude of the force exerted by q_{1} on q_{2} is given by F=\frac{kq_{1}q_{2}}{r^{2}} where k is the Coulomb constant, q_{1} and q_{2} are the charges of the particles, and r is the distance between them.
Muhammed
What is the direction and net electric force on q_{1}= 5µC located at (0,4)r due to charges q_{2}=7mu located at (0,0)m and q_{3}=3\mu C located at (4,0)m?
Kate Reply
what is the change in momentum of a body?
Eunice Reply
what is a capacitor?
Raymond Reply
Capacitor is a separation of opposite charges using an insulator of very small dimension between them. Capacitor is used for allowing an AC (alternating current) to pass while a DC (direct current) is blocked.
Gautam
A motor travelling at 72km/m on sighting a stop sign applying the breaks such that under constant deaccelerate in the meters of 50 metres what is the magnitude of the accelerate
Maria Reply
please solve
Sharon
8m/s²
Aishat
What is Thermodynamics
Muordit
velocity can be 72 km/h in question. 72 km/h=20 m/s, v^2=2.a.x , 20^2=2.a.50, a=4 m/s^2.
Mehmet
A boat travels due east at a speed of 40meter per seconds across a river flowing due south at 30meter per seconds. what is the resultant speed of the boat
Saheed Reply
50 m/s due south east
Someone
which has a higher temperature, 1cup of boiling water or 1teapot of boiling water which can transfer more heat 1cup of boiling water or 1 teapot of boiling water explain your . answer
Ramon Reply
I believe temperature being an intensive property does not change for any amount of boiling water whereas heat being an extensive property changes with amount/size of the system.
Someone
Scratch that
Someone
temperature for any amount of water to boil at ntp is 100⁰C (it is a state function and and intensive property) and it depends both will give same amount of heat because the surface available for heat transfer is greater in case of the kettle as well as the heat stored in it but if you talk.....
Someone
about the amount of heat stored in the system then in that case since the mass of water in the kettle is greater so more energy is required to raise the temperature b/c more molecules of water are present in the kettle
Someone
definitely of physics
Haryormhidey Reply
how many start and codon
Esrael Reply
what is field
Felix Reply
physics, biology and chemistry this is my Field
ALIYU
field is a region of space under the influence of some physical properties
Collete
what is ogarnic chemistry
WISDOM Reply
determine the slope giving that 3y+ 2x-14=0
WISDOM
Another formula for Acceleration
Belty Reply
a=v/t. a=f/m a
IHUMA
innocent
Adah
pratica A on solution of hydro chloric acid,B is a solution containing 0.5000 mole ofsodium chlorid per dm³,put A in the burret and titrate 20.00 or 25.00cm³ portion of B using melting orange as the indicator. record the deside of your burret tabulate the burret reading and calculate the average volume of acid used?
Nassze Reply
how do lnternal energy measures
Esrael
Two bodies attract each other electrically. Do they both have to be charged? Answer the same question if the bodies repel one another.
JALLAH Reply
No. According to Isac Newtons law. this two bodies maybe you and the wall beside you. Attracting depends on the mass och each body and distance between them.
Dlovan
Are you really asking if two bodies have to be charged to be influenced by Coulombs Law?
Robert
like charges repel while unlike charges atttact
Raymond
What is specific heat capacity
Destiny Reply
Specific heat capacity is a measure of the amount of energy required to raise the temperature of a substance by one degree Celsius (or Kelvin). It is measured in Joules per kilogram per degree Celsius (J/kg°C).
AI-Robot
specific heat capacity is the amount of energy needed to raise the temperature of a substance by one degree Celsius or kelvin
ROKEEB
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 4

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Chemistry. OpenStax CNX. May 20, 2015 Download for free at http://legacy.cnx.org/content/col11760/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Chemistry' conversation and receive update notifications?

Ask