<< Chapter < Page Chapter >> Page >

Some common solubility products are listed in [link] according to their K sp values, whereas a more extensive compilation of products appears in Appendix J . Each of these equilibrium constants is much smaller than 1 because the compounds listed are only slightly soluble. A small K sp represents a system in which the equilibrium lies to the left, so that relatively few hydrated ions would be present in a saturated solution.

Common Solubility Products by Decreasing Equilibrium Constants
Substance K sp at 25 °C
CuCl 1.2 × 10 –6
CuBr 6.27 × 10 –9
AgI 1.5 × 10 –16
PbS 7 × 10 –29
Al(OH) 3 2 × 10 –32
Fe(OH) 3 4 × 10 –38

Writing equations and solubility products

Write the ionic equation for the dissolution and the solubility product expression for each of the following slightly soluble ionic compounds:

(a) AgI, silver iodide, a solid with antiseptic properties

(b) CaCO 3 , calcium carbonate, the active ingredient in many over-the-counter chewable antacids

(c) Mg(OH) 2 , magnesium hydroxide, the active ingredient in Milk of Magnesia

(d) Mg(NH 4 )PO 4 , magnesium ammonium phosphate, an essentially insoluble substance used in tests for magnesium

(e) Ca 5 (PO 4 ) 3 OH, the mineral apatite, a source of phosphate for fertilizers

(Hint: When determining how to break (d) and (e) up into ions, refer to the list of polyatomic ions in the section on chemical nomenclature.)

Solution

(a) AgI ( s ) Ag + ( a q ) + I ( a q ) K sp = [ Ag + ] [ I ]

(b) CaCO 3 ( s ) Ca 2+ ( a q ) + CO 3 2− ( a q ) K sp = [ Ca 2+ ] [ CO 3 2− ]

(c) Mg ( OH ) 2 ( s ) Mg 2+ ( a q ) + 2OH ( a q ) K sp = [ Mg 2+ ] [ OH ] 2

(d) Mg ( NH 4 ) PO 4 ( s ) Mg 2+ ( a q ) + NH 4 + ( a q ) + PO 4 3− ( a q ) K sp = [ Mg 2+ ] [ NH 4 + ] [ PO 4 3− ]

(e) Ca 5 ( PO 4 ) 3 OH ( s ) 5Ca 2+ ( a q ) + 3PO 4 3− ( a q ) + OH ( a q ) K sp = [ Ca 2+ ] 5 [ P O 4 3− ] 3 [ OH ]

Check your learning

Write the ionic equation for the dissolution and the solubility product for each of the following slightly soluble compounds:

(a) BaSO 4

(b) Ag 2 SO 4

(c) Al(OH) 3

(d) Pb(OH)Cl

Answer:

(a) BaSO 4 ( s ) Ba 2+ ( a q ) + SO 4 2− ( a q ) K sp = [ Ba 2+ ] [ SO 4 2 ] ; (b) Ag 2 SO 4 ( s ) 2Ag + ( a q ) + SO 4 2− ( a q ) K sp = [ Ag + ] 2 [ SO 4 2− ] ; (c) Al ( OH ) 3 ( s ) Al 2+ ( a q ) + 3OH ( a q ) K sp = [ Al 3+ ] [ OH ] 3 ; (d) Pb(OH)Cl( s ) Pb 2+ ( a q ) + OH ( a q ) + Cl ( a q ) K sp = [ Pb 2+ ] [ OH ] [ Cl ]

Got questions? Get instant answers now!

Now we will extend the discussion of K sp and show how the solubility product constant is determined from the solubility of its ions, as well as how K sp can be used to determine the molar solubility of a substance.

K sp And solubility

Recall that the definition of solubility is the maximum possible concentration of a solute in a solution at a given temperature and pressure. We can determine the solubility product of a slightly soluble solid from that measure of its solubility at a given temperature and pressure, provided that the only significant reaction that occurs when the solid dissolves is its dissociation into solvated ions, that is, the only equilibrium involved is:

M p X q ( s ) p M m+ ( a q ) + q X n− ( a q )

In this case, we calculate the solubility product by taking the solid’s solubility expressed in units of moles per liter (mol/L), known as its molar solubility    .

Calculation of K sp From equilibrium concentrations

We began the chapter with an informal discussion of how the mineral fluorite ( [link] ) is formed. Fluorite, CaF 2 , is a slightly soluble solid that dissolves according to the equation:

CaF 2 ( s ) Ca 2+ ( a q ) + 2F ( a q )

The concentration of Ca 2+ in a saturated solution of CaF 2 is 2.15 × 10 –4 M ; therefore, that of F is 4.30 × 10 –4 M , that is, twice the concentration of Ca 2+ . What is the solubility product of fluorite?

Solution

First, write out the K sp expression, then substitute in concentrations and solve for K sp :

CaF 2 ( s ) Ca 2+ ( a q ) + 2F ( a q )

A saturated solution is a solution at equilibrium with the solid. Thus:

K sp = [ Ca 2+ ] [ F ] 2 = (2.1 × 10 4 ) ( 4.2 × 10 4 ) 2 = 3.7 × 10 11

As with other equilibrium constants, we do not include units with K sp .

Check your learning

In a saturated solution that is in contact with solid Mg(OH) 2 , the concentration of Mg 2+ is 1.31 × 10 –4 M . What is the solubility product for Mg(OH) 2 ?

Mg(OH) 2 ( s ) Mg 2+ ( a q ) + 2OH ( a q )

Answer:

8.99 × 10 –12

Got questions? Get instant answers now!

Questions & Answers

if three forces F1.f2 .f3 act at a point on a Cartesian plane in the daigram .....so if the question says write down the x and y components ..... I really don't understand
Syamthanda Reply
hey , can you please explain oxidation reaction & redox ?
Boitumelo Reply
hey , can you please explain oxidation reaction and redox ?
Boitumelo
for grade 12 or grade 11?
Sibulele
the value of V1 and V2
Tumelo Reply
advantages of electrons in a circuit
Rethabile Reply
we're do you find electromagnetism past papers
Ntombifuthi
what a normal force
Tholulwazi Reply
it is the force or component of the force that the surface exert on an object incontact with it and which acts perpendicular to the surface
Sihle
what is physics?
Petrus Reply
what is the half reaction of Potassium and chlorine
Anna Reply
how to calculate coefficient of static friction
Lisa Reply
how to calculate static friction
Lisa
How to calculate a current
Tumelo
how to calculate the magnitude of horizontal component of the applied force
Mogano
How to calculate force
Monambi
a structure of a thermocouple used to measure inner temperature
Anna Reply
a fixed gas of a mass is held at standard pressure temperature of 15 degrees Celsius .Calculate the temperature of the gas in Celsius if the pressure is changed to 2×10 to the power 4
Amahle Reply
How is energy being used in bonding?
Raymond Reply
what is acceleration
Syamthanda Reply
a rate of change in velocity of an object whith respect to time
Khuthadzo
how can we find the moment of torque of a circular object
Kidist
Acceleration is a rate of change in velocity.
Justice
t =r×f
Khuthadzo
how to calculate tension by substitution
Precious Reply
hi
Shongi
hi
Leago
use fnet method. how many obects are being calculated ?
Khuthadzo
khuthadzo hii
Hulisani
how to calculate acceleration and tension force
Lungile Reply
you use Fnet equals ma , newtoms second law formula
Masego
please help me with vectors in two dimensions
Mulaudzi Reply
how to calculate normal force
Mulaudzi
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 4

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Chemistry. OpenStax CNX. May 20, 2015 Download for free at http://legacy.cnx.org/content/col11760/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Chemistry' conversation and receive update notifications?

Ask