1. Home
  2. Chemistry
  3. Thermochemistry
  4. Enthalpy

5.3 Enthalpy  (Page 7/25)

<< Chapter < Page
  Chemistry     Page 7 / 25
Chapter >> Page >

Writing reaction equations for Δ H f °

Write the heat of formation reaction equations for:

(a) C 2 H 5 OH( l )

(b) Ca 3 (PO 4 ) 2 ( s )

Solution

Remembering that Δ H f ° reaction equations are for forming 1 mole of the compound from its constituent elements under standard conditions, we have:

(a) 2 C ( s , graphite ) + 3 H 2 ( g ) + 1 2 O 2 ( g ) ⟶ C 2 H 5 OH ( l )

(b) 3 Ca ( s ) + 1 2 P 4 ( s ) + 4 O 2 ( g ) ⟶ Ca 3 ( PO 4 ) 2 ( s )

Note: The standard state of carbon is graphite, and phosphorus exists as P 4 .

Check your learning

Write the heat of formation reaction equations for:

(a) C 2 H 5 OC 2 H 5 ( l )

(b) Na 2 CO 3 ( s )

Answer:

(a) 4 C ( s , graphite ) + 5 H 2 ( g ) + 1 2 O 2 ( g ) ⟶ C 2 H 5 OC 2 H 5 ( l ) ; (b) 2 Na ( s ) + C ( s , graphite ) + 3 2 O 2 ( g ) ⟶ Na 2 CO 3 ( s )

Got questions? Get instant answers now!

Hess’s law

There are two ways to determine the amount of heat involved in a chemical change: measure it experimentally, or calculate it from other experimentally determined enthalpy changes. Some reactions are difficult, if not impossible, to investigate and make accurate measurements for experimentally. And even when a reaction is not hard to perform or measure, it is convenient to be able to determine the heat involved in a reaction without having to perform an experiment.

This type of calculation usually involves the use of Hess’s law    , which states: If a process can be written as the sum of several stepwise processes, the enthalpy change of the total process equals the sum of the enthalpy changes of the various steps . Hess’s law is valid because enthalpy is a state function: Enthalpy changes depend only on where a chemical process starts and ends, but not on the path it takes from start to finish. For example, we can think of the reaction of carbon with oxygen to form carbon dioxide as occurring either directly or by a two-step process. The direct process is written:

C ( s ) + O 2 ( g ) ⟶ CO 2 ( g ) Δ H 298 ° = −394 kJ

In the two-step process, first carbon monoxide is formed:

C ( s ) + 1 2 O 2 ( g ) ⟶ CO ( g ) Δ H 298 ° = −111 kJ

Then, carbon monoxide reacts further to form carbon dioxide:

CO ( g ) + 1 2 O 2 ( g ) ⟶ CO 2 ( g ) Δ H 298 ° = −283 kJ

The equation describing the overall reaction is the sum of these two chemical changes:

Step 1: C ( s ) + 1 2 O 2 ( g ) ⟶ CO ( g ) Step 2: CO ( g ) + 1 2 O 2 ( g ) ⟶ CO 2 ( g ) ¯ Sum: C ( s ) + 1 2 O 2 ( g ) + CO ( g ) + 1 2 O 2 ( g ) ⟶ CO ( g ) + CO 2 ( g )

Because the CO produced in Step 1 is consumed in Step 2, the net change is:

C ( s ) + O 2 ( g ) ⟶ CO 2 ( g )

According to Hess’s law, the enthalpy change of the reaction will equal the sum of the enthalpy changes of the steps. We can apply the data from the experimental enthalpies of combustion in [link] to find the enthalpy change of the entire reaction from its two steps:

C ( s ) + 1 2 O 2 ( g ) ⟶ CO ( g ) Δ H 298 ° = −111 kJ CO ( g ) + 1 2 O 2 ( g ) ⟶ CO 2 ( g ) C ( s ) + O 2 ( g ) ⟶ CO 2 ( g ) Δ H 298 ° = −283 kJ Δ H 298 ° = −394 kJ

The result is shown in [link] . We see that Δ H of the overall reaction is the same whether it occurs in one step or two. This finding (overall Δ H for the reaction = sum of Δ H values for reaction “steps” in the overall reaction) is true in general for chemical and physical processes.

A diagram is shown. A long arrow faces upward on the left with the phrase “H increasing.” A horizontal line at the bottom of the diagram is shown with the formula “C O subscript 2 (g)” below it. A horizontal line at the top of the diagram has the formulas “C (s) + O subscript 2 (g)” above it. The top and bottom lines are connected by a downward facing arrow with the value “Δ H = –394 k J” written beside it. Below and to the right of the top horizontal line is a second horizontal line with the equations “C O (g) + one half O subscript 2 (g)” above it. This line and the bottom line are connected by a downward facing arrow with the value “Δ H = –283 k J” written beside it. The same line and the top line are connected by a downward facing arrow with the value “Δ H = –111 k J” written beside it. There are three brackets to the right of the diagram. The first bracket runs from the top horizontal line to the second horizontal line. It is labeled, “Enthalpy of reactants.” The second bracket runs from the second horizontal line to the bottom horizontal line. It is labeled, “Enthalpy of products.” Both of these brackets are included in the third bracket which runs from the top to the bottom of the diagram. It is labeled, “Enthalpy change of exothermic reaction in 1 or 2 steps.”
The formation of CO 2 ( g ) from its elements can be thought of as occurring in two steps, which sum to the overall reaction, as described by Hess’s law. The horizontal blue lines represent enthalpies. For an exothermic process, the products are at lower enthalpy than are the reactants.

Questions & Answers

how do you get the 2/50
Abba Reply
number of sport play by 50 student construct discrete data
Aminu Reply
width of the frangebany leaves on how to write a introduction
Theresa Reply
Solve the mean of variance
Veronica Reply
Step 1: Find the mean. To find the mean, add up all the scores, then divide them by the number of scores. ... Step 2: Find each score's deviation from the mean. ... Step 3: Square each deviation from the mean. ... Step 4: Find the sum of squares. ... Step 5: Divide the sum of squares by n – 1 or N.
kenneth
what is error
Yakuba Reply
Is mistake done to something
Vutshila
Hy
anas
hy
What is the life teble
anas
hy
Jibrin
statistics is the analyzing of data
Tajudeen Reply
what is statics?
Zelalem Reply
how do you calculate mean
Gloria Reply
diveving the sum if all values
Shaynaynay
let A1,A2 and A3 events be independent,show that (A1)^c, (A2)^c and (A3)^c are independent?
Fisaye Reply
what is statistics
Akhisani Reply
data collected all over the world
Shaynaynay
construct a less than and more than table
Imad Reply
The sample of 16 students is taken. The average age in the sample was 22 years with astandard deviation of 6 years. Construct a 95% confidence interval for the age of the population.
Aschalew Reply
Bhartdarshan' is an internet-based travel agency wherein customer can see videos of the cities they plant to visit. The number of hits daily is a normally distributed random variable with a mean of 10,000 and a standard deviation of 2,400 a. what is the probability of getting more than 12,000 hits? b. what is the probability of getting fewer than 9,000 hits?
Akshay Reply
Bhartdarshan'is an internet-based travel agency wherein customer can see videos of the cities they plan to visit. The number of hits daily is a normally distributed random variable with a mean of 10,000 and a standard deviation of 2,400. a. What is the probability of getting more than 12,000 hits
Akshay
1
Bright
Sorry i want to learn more about this question
Bright
Someone help
Bright
a= 0.20233 b=0.3384
Sufiyan
a
Shaynaynay
How do I interpret level of significance?
Mohd Reply
It depends on your business problem or in Machine Learning you could use ROC- AUC cruve to decide the threshold value
Shivam
how skewness and kurtosis are used in statistics
Owen Reply
yes what is it
Taneeya
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
<< Chapter < Page Page > Chapter >>
Practice Key Terms 12

Read also:

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Chemistry. OpenStax CNX. May 20, 2015 Download for free at http://legacy.cnx.org/content/col11760/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Chemistry' conversation and receive update notifications?

Ask