<< Chapter < Page Chapter >> Page >

Exercises

Which of the following is/ are independent of the angle of projection of a projectile :

(a) time of flight

(b) maximum height reached

(c) acceleration of projectile

(d) horizontal component of velocity

The time of flight is determined by considering vertical motion. It means that time of flight is dependent on speed and the angle of projection.

T = 2 u y g = 2 u sin θ g

Maximum height is also determined, considering vertical motion. As such, maximum height also depends on the angle of projection.

H = u y 2 2 g = u 2 sin 2 θ 2 g

Horizontal component, being component of velocity, depends on the angle of projection.

u y = u cos θ

It is only the acceleration of projectile, which is equal to acceleration due to gravity and is, therefore, independent of the angle of projection. Hence, option (c) is correct.

Got questions? Get instant answers now!

Two particles are projected with same initial speeds at 30° and 60° with the horizontal. Then

(a) their maximum heights will be equal

(b) their ranges will be equal

(c) their time of flights will be equal

(d) their ranges will be different

The maximum heights, ranges and time of lights are compared, using respective formula as :

(i)Maximum Height

H 1 H 2 = u 2 sin 2 θ 1 u 2 sin 2 θ 2 = sin 2 30 0 sin 2 60 0 = 1 2 2 3 2 2 = 1 3

Thus, the maximum heights attained by two projectiles are unequal.

(ii) Range :

R 1 R 2 = u 2 sin 2 θ 1 u 2 sin 2 θ 2 = sin 2 60 0 sin 2 120 0 = 3 2 2 3 2 2 = 1 1

Thus, the ranges of two projectiles are equal.

(iii) Time of flight

T 1 T 2 = 2 u sin θ 1 2 u sin θ 2 = sin 30 0 sin 60 0 = 1 2 3 2 = 1 3

Thus, the times of flight of two projectiles are unequal.

Hence, option (b) is correct.

Got questions? Get instant answers now!

The velocity of a projectile during its flight at an elevation of 8 m from the ground is 3 i - 5 j in the coordinate system, where x and y directions represent horizontal and vertical directions respectively. The maximum height attained (H) by the particle is :

a 10.4 m b 8.8 m c 9.25 m d 9 m

We note that vertical component is negative, meaning that projectile is moving towards the ground. The vertical component of velocity 8 m above the ground is

v y = - 5 m / s

The vertical displacement (y) from the maximum height to the point 8 m above the ground as shown in the figure can be obtained, using equation of motion.

Projectile motion

Projectile motion

v y 2 = u y 2 + 2 a y

Considering the point under consideration as origin and upward direction as positive direction.

- 5 2 = 0 + 2 X - 10 X h h = - 25 / 20 = - 1.25 m

Thus, the maximum height, H, attained by the projectile is :

H = 8 + 1.25 = 9.25 m

Hence, option (c) is correct.

Got questions? Get instant answers now!

A projectile is thrown with a given speed so as to cover maximum range (R). If "H" be the maximum height attained during the throw, then the range "R" is equal to :

a 4 H b 3 H c 2 H d H

The projectile covers maximum range when angle of projection is equal to 45°. The maximum range "R" is given by :

R = u 2 sin 2 θ g = u 2 sin 90 0 g = u 2 g

On the other hand, the maximum height attained by the projectile for angle of projection, 45°, is :

H = u y 2 2 g = u 2 sin 2 45 0 2 g = u 2 4 g

Comparing expressions of range and maximum height, we have :

R = 4 H

Hence, option (a) is correct.

Got questions? Get instant answers now!

The speed of a projectile at maximum height is half its speed of projection, "u". The horizontal range of the projectile is :

a 3 u 2 g b 3 u 2 2 g c u 2 4 g d u 2 2 g

The horizontal range of the projectile is given as :

R = u 2 sin 2 θ g

In order to evaluate this expression, we need to know the angle of projection. Now, the initial part of the question says that the speed of a projectile at maximum height is half its speed of projection, "u". However, we know that speed of the projectile at the maximum height is equal to the horizontal component of projection velocity,

u cos θ = u 2 cos θ = 1 2 = cos 30 0 θ = 30 0

The required range is :

R = u 2 sin 2 θ g = u 2 sin 60 0 g = 3 u 2 2 g

Hence, option (b) is correct.

Got questions? Get instant answers now!

Let " T 1 ” and “ T 2 ” be the times of flights of a projectile for projections at two complimentary angles for which horizontal range is "R". The product of times of flight, " T 1 T 2 ”, is equal to :

a R g b R 2 g c 2 R g d R 2 g

Here, we are required to find the product of times of flight. Let " θ " and " 90 0 θ " be two angles of projections. The times of flight are given as :

T 1 = 2 u sin θ g

and

T 2 = 2 u sin 90 0 θ g = 2 u cos θ g

Hence,

T 1 T 2 = 4 u 2 sin θ cos θ g 2

But,

R = 2 u 2 sin θ cos θ g

Combining two equations,

T 1 T 2 = 2 R g

Hence, option (c) is correct.

Got questions? Get instant answers now!

A projectile is projected with a speed "u" at an angle " θ " from the horizontal. The magnitude of average velocity between projection and the time, when projectile reaches the maximum height.

a u cos 2 θ b 3 u 2 cos θ + 1

c 3 u 2 cos θ + 1 2 u d u 3 u 2 cos θ + 1 2

The magnitude of average velocity is given as :

v a v g = Displacement Time

Now the displacement here is OA as shown in the figure. From right angle triangle OAC,

Projectile motion

Projectile motion

O A = O C 2 + B C 2 = { R 2 2 + H 2 } O A = R 2 4 + H 2

Hence, magnitude of average velocity is :

v a v g = R 2 4 + H 2 T

Substituting expression for each of the terms, we have :

v a v g = u 4 sin 2 2 θ 4 g 2 + u 4 sin 4 θ 4 g 2 2 u sin θ g

vavg = u(3 u2cos + 1)/2 v a v g = u 3 u 2 cos θ + 1 2

Hence, option (d) is correct.

Got questions? Get instant answers now!

A projectile is projected at an angle " θ " from the horizon. The tangent of angle of elevation of the highest point as seen from the position of projection is :

a tan θ 4 b tan θ 2 c tan θ d 3 tan θ 2

The angle of elevation of the highest point " θ " is shown in the figure. Clearly,

Projectile motion

Projectile motion

tan α = A C O C = H R 2 = 2 H R

Putting expressions of the maximum height and range of the flight, we have :

tan α = 2 u 2 sin 2 θ X g 2 g X u 2 sin 2 θ = sin 2 θ 2 sin θ cos θ = tan θ 2

Hence, option (b) is correct.

Got questions? Get instant answers now!

In a firing range, shots are taken at different angles and in different directions. If the speed of the bullets is "u", then find the area in which bullets can spread.

a 2 π u 4 g 2 b u 4 g 2 c π u 4 g 2 d π u 2 g 2

The bullets can spread around in a circular area of radius equal to maximum horizontal range. The maximum horizontal range is given for angle of projection of 45°.

R max = u 2 sin 2 θ g = u 2 sin 2 X 45 0 g = u 2 sin 90 0 g = u 2 g

The circular area corresponding to the radius equal to maximum horizontal range is given as :

A = π R max 2 = π X u 2 g 2 = π u 4 g 2

Hence, option (c) is correct.

Got questions? Get instant answers now!

More exercises

Check the module titled " Features of projectile motion (application) to work out more problems.

Questions & Answers

how does Neisseria cause meningitis
Nyibol Reply
what is microbiologist
Muhammad Reply
what is errata
Muhammad
is the branch of biology that deals with the study of microorganisms.
Ntefuni Reply
What is microbiology
Mercy Reply
studies of microbes
Louisiaste
when we takee the specimen which lumbar,spin,
Ziyad Reply
How bacteria create energy to survive?
Muhamad Reply
Bacteria doesn't produce energy they are dependent upon their substrate in case of lack of nutrients they are able to make spores which helps them to sustain in harsh environments
_Adnan
But not all bacteria make spores, l mean Eukaryotic cells have Mitochondria which acts as powerhouse for them, since bacteria don't have it, what is the substitution for it?
Muhamad
they make spores
Louisiaste
what is sporadic nd endemic, epidemic
Aminu Reply
the significance of food webs for disease transmission
Abreham
food webs brings about an infection as an individual depends on number of diseased foods or carriers dully.
Mark
explain assimilatory nitrate reduction
Esinniobiwa Reply
Assimilatory nitrate reduction is a process that occurs in some microorganisms, such as bacteria and archaea, in which nitrate (NO3-) is reduced to nitrite (NO2-), and then further reduced to ammonia (NH3).
Elkana
This process is called assimilatory nitrate reduction because the nitrogen that is produced is incorporated in the cells of microorganisms where it can be used in the synthesis of amino acids and other nitrogen products
Elkana
Examples of thermophilic organisms
Shu Reply
Give Examples of thermophilic organisms
Shu
advantages of normal Flora to the host
Micheal Reply
Prevent foreign microbes to the host
Abubakar
they provide healthier benefits to their hosts
ayesha
They are friends to host only when Host immune system is strong and become enemies when the host immune system is weakened . very bad relationship!
Mark
what is cell
faisal Reply
cell is the smallest unit of life
Fauziya
cell is the smallest unit of life
Akanni
ok
Innocent
cell is the structural and functional unit of life
Hasan
is the fundamental units of Life
Musa
what are emergency diseases
Micheal Reply
There are nothing like emergency disease but there are some common medical emergency which can occur simultaneously like Bleeding,heart attack,Breathing difficulties,severe pain heart stock.Hope you will get my point .Have a nice day ❣️
_Adnan
define infection ,prevention and control
Innocent
I think infection prevention and control is the avoidance of all things we do that gives out break of infections and promotion of health practices that promote life
Lubega
Heyy Lubega hussein where are u from?
_Adnan
en français
Adama
which site have a normal flora
ESTHER Reply
Many sites of the body have it Skin Nasal cavity Oral cavity Gastro intestinal tract
Safaa
skin
Asiina
skin,Oral,Nasal,GIt
Sadik
How can Commensal can Bacteria change into pathogen?
Sadik
How can Commensal Bacteria change into pathogen?
Sadik
all
Tesfaye
by fussion
Asiina
what are the advantages of normal Flora to the host
Micheal
what are the ways of control and prevention of nosocomial infection in the hospital
Micheal
what is inflammation
Shelly Reply
part of a tissue or an organ being wounded or bruised.
Wilfred
what term is used to name and classify microorganisms?
Micheal Reply
Binomial nomenclature
adeolu
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Physics for k-12. OpenStax CNX. Sep 07, 2009 Download for free at http://cnx.org/content/col10322/1.175
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Physics for k-12' conversation and receive update notifications?

Ask