0.12 Non-renewable energy sources  (Page 2/3)

Coal is used to produce over 50% of the electricity in the United States. In addition to electricity production, coal is sometimes used for heating and cooking in less developed countries and in rural areas of developed countries. If consumption continues at the same rate, the current reserves will last for more than 200 years. The burning of coal results in significant atmospheric pollution. The sulfur contained in coal forms sulfur dioxide when burned. Harmful nitrogen oxides, heavy metals, and carbon dioxide are also released into the air during coal burning. The harmful emissions can be reduced by installing scrubbers and electrostatic precipitators in the smokestacks of power plants. The toxic ash remaining after coal burning is also an environmental concern and is usually disposed into landfills.

Oil

Crude oil or liquid petroleum, is a fossil fuel that is refined into many different energy products (e.g., gasoline, diesel fuel, jet fuel, heating oil). Oil forms underground in rock such as shale , which is rich in organic materials. After the oil forms, it migrates upward into porous reservoir rock such as sandstone or limestone, where it can become trapped by an overlying impermeable cap rock. Wells are drilled into these oil reservoirs to remove the gas and oil. Over 70 percent of oil fields are found near tectonic plate boundaries, because the conditions there are conducive to oil formation.

Oil recovery can involve more than one stage. The primary stage involves pumping oil from reservoirs under the normal reservoir pressure. About 25 percent of the oil in a reservoir can be removed during this stage. The secondary recovery stage involves injecting hot water into the reservoir around the well. This water forces the remaining oil toward the area of the well from which it can be recovered. Sometimes a tertiary method of recovery is used in order to remove as much oil as possible. This involves pumping steam, carbon dioxide gas or nitrogen gas into the reservoir to force the remaining oil toward the well. Tertiary recovery is very expensive and can cost up to half of the value of oil removed. Carbon dioxide used in this method remains sequestered in the deep reservoir, thus mitigating its potential greenhouse effect on the atmosphere. The refining process required to convert crude oil into useable hydrocarbon compounds involves boiling the crude and separating the gases in a process known as fractional distillation. Besides its use as a source of energy, oil also provides base material for plastics, provides asphalt for roads and is a source of industrial chemicals.

Over 50 percent of the world's oil is found in the Middle East; sizeable additional reserves occur in North America. Most known oil reserves are already being exploited, and oil is being used at a rate that exceeds the rate of discovery of new sources. If the consumption rate continues to increase and no significant new sources are found, oil supplies may be exhausted in another 30 years or so.